SMC is a thermosetting reinforced plastic with the following characteristics:;
1. The stability of the line expansion standard is good, and the cold and hot deformation system is very small.
2. Good creep and fatigue function.
3. High mechanical strength, with an impact resistance of up to 90KJ and a bending strength of up to 170MPa.
4. High water resistance, due to its water absorption rate of only 20mg/m2.
5. Good corrosion resistance, with minimal corrosion from various acids and bases.
6. The temperature resistance indicator is high, and its thermal deformation temperature can reach 230 ℃.
7. High flame retardant function, its incineration hazard function is above 960 ℃, and its flame retardant function can reach V-0 level of VL-94 standard.
8. High electrical function, with a volume resistance of up to 1× 1014Ω, The withstand voltage can reach 12KV/mm.
9. It has strong resistance to natural aging and will not undergo significant changes or transformations after 15 years of use under natural conditions.
The article originates fromSMC molded products http://www.jmlicheng.com/
04-29
Types of sheets used for SMC products
Common fiberglass processes include hand lay up, RTM, pultrusion, and compression molding, with steel molds used for mass production of pultrusion and compression molding. Molding strengths: (1) The m
03-25
SMC fiberglass mold laying steps
SMC mold is a combination plastic mold used for compression molding, extrusion molding, injection molding, blow molding, and low foaming molding. It mainly consists of a concave mold with a variable c
02-25
What are the characteristics of SMC molded insulation board
SMC is a thermosetting reinforced plastic with the following characteristics:;1. The stability of the line expansion standard is good, and the cold and hot deformation system is very small.2. Good cre
01-09
How to improve the quality of SMC products
The molding quality of SMC accessories depends on factors such as press equipment, molds, technical parameters, and the quality of operators. The excellent and stable quality of SMC molded parts not o